We strictly maintain the shade range of the merchandise as desired by the client. While producing cut to size/ Tiles, careful batching is done even when the material is cut from a same slab/block.

We do the repairing / netting to reasonable levels and not to the extent of joining two broken pieces. Moreover, more importantly. we use low viscosity epoxy based resins specially produced in Italy & Germany for stone application. We never use cheaper polyester-based resins, which have a limited life.

While sawing, especially Green Marble, we take a lot of care, as it is a very brittle and pasty material. A little less carefulness and the result is taper slabs like

We maintain a very low down feed and regularly monitor the sharpness of diamonds to ensure maximum tolerance of +/-0.5 mm within a same slab.

At Sarla Exports we have carefully controlled this very common and major problem. We never let the sawing result in slabs with a curve/bow, which makes the fabrication/ installation very difficult.

we always maintain flatness of slabs to the permissible tolerance limit.

We polish the Marble Slabs & Tiles on automatic multiple head line polishing machines from Breton spa & Terzago spa of Italy. We never supply merchandise polished on "locally made table polishing machines". We achieve the gloss between 75°-90° and gaurantee an excellent flatness, proper pre bed preparation and suitable life of the gloss at international Quality Standards.

We maintain perfect squareness in cut to size materials, thanks to the automatic bridge cutting machine from Breton SPA, Italy. We never use locally made bridge cutting machines or conventional hand driven edge cutting machines as it is far than difficult to maintain size and squareness accuracy on such machines.